Article - CS147215
"All entities must be on the same side of the revolving axis." message reported when config option "sketcher_starts_in_2d" set to "yes" in Creo Parametric 2.0
Modified: 13-Jun-2017
Applies To
- Creo Parametric 2.0 F000 to M080
Description
-
With config option sketcher_starts_in_2d set to yes, centerline created in blend feature is designated as Axis of Revolution
- Reports message All entities must be on the same side of the revolving axis.
- When validating sketch, Incomplete Section dialog box popups with Section is incomplete for reasons listed in message area. Exit sketcher? message
- In trail file and Feature Requirements dialog box, All entities must be on the same side of the revolving axis. warning is present
This is a printer-friendly version of Article 147215 and may be out of date. For the latest version click CS147215