Article - CS66443
How to control the visibility of center line for radius or diameter dimensions in Creo Elements/Direct Modeling Annotation
Modified: 23-Jun-2023
Applies To
- Creo Elements/Direct Modeling 15.00 to 20.5
Description
- How to apply a radius or diameter dimension without the line extending from the arc or circle to the center?
- How to set diameter and radius dimensions to display no centerline by default?
- How to switch ON and OFF for diameter and radius dimension center line?
- Is it possible to add or remove the centerline from an existing radius dimension?
- Is it possible to change an existing radius dimension to show or not show the centerline?
This is a printer-friendly version of Article 66443 and may be out of date. For the latest version click CS66443