Article - CS4887
Circular reference created in part mode is only visible as circular reference warning in assembly mode of Creo Parametric 2.0
Modified: 09-Sep-2015
Applies To
- Pro/ENGINEER and Creo Elements/Pro Wildfire 5.0 F000 to M270
- Creo Parametric 2.0 F000 to M180
Description
- Circular reference created in part mode is only visible as circular reference warning in assembly mode
- Sketch feature will be referenced by an offset cross section that cuts a protrusion feature
- If sketch feature will be moved after the protrusion feature there is no issue when doing a forced regeneration via Model Player in part mode
- However assembling this part into any assembly followed by a simple regeneration there is the message:
1 circular references found. Info stored in file asm0001.crc.
- Content Of asm0001.crc:
1 CIRCULAR REFERENCE LOOPS FOUND
LOOP # 1
Depth of loop is 3
Feature number 10 (COSMETIC, id = 110)
in model PRT0001 refers to:
Feature number 11 (SKETCH_1, id = 100)
in model PRT0001 must follow after:
Feature number 10 (COSMETIC, id = 110)
in model PRT0001 - circle closed.
Note: Instead of SKETCH it could also be listed HOLE or PATTERN for instance.
This is a printer-friendly version of Article 4887 and may be out of date. For the latest version click CS4887