Article - CS433409
How to create Ball-End Mill machined geometry along a cylindrical surface in PTC Creo Parametric
Modified: 12-Dec-2024
Applies To
- Creo Parametric 9.0
Description
- How to create Ball-End Mill machined geometry along a cylindrical surface in PTC Creo Parametric
- Users are unable to create geometry with Ball-End Mill machining along a cylindrical surface using the Sweep command
- The Sweep command results in flat start and end points, not representative of Ball-End Mill machining.
This is a printer-friendly version of Article 433409 and may be out of date. For the latest version click CS433409