Article - CS407705
WIndchill PDMLink: For SolidWorks if preference "Independently Modify Instances" is set to Yes then Checkout fails with error "New models must be checked in first" when all Instances removed from workspace
Modified: 03-Jan-2024
Applies To
- Windchill PDMLink 11.0 to 13.0
- Windchill Workgroup Manager
- Solidworks
Description
- For SolidWorks if preference "Independently Modify Instances" is set to Yes then Checkout fails with error "New models must be checked in first" when all Instances removed from workspace
- Steps to reproduce issue:-
- Preference Independently Modify Instances is set to Yes for SolidWorks
- Launch WGM and Solidworks
- Open Generic part from local disk and perform save to workspace and Check in Generic from workspace
- Remove All instances from workspace
- Perform Checkout from Solidworks session,checkout failed with an error
-
“ New models must be checked in first: ABC.SLDPRT”
-
This is a printer-friendly version of Article 407705 and may be out of date. For the latest version click CS407705