Article - CS401612
F2 key running a mapkey which opens and closes Tree is not effective in Drawing environment when "Hatch Tree" is opened in Creo Parametric 9.0
Modified: 20-Sep-2023
Applies To
- Creo Parametric 9.0
Description
- F2 key running a mapkey which opens and closes Tree is:
- effective:
- in all modes (PRT, ASM, MANUFACTURING ASM, etc...)
- including DRAWING mode, as long as Hatch Tree is closed
- unexpectedly not effective in DRAWING mode when Hatch Tree is opened
- effective:
- Above behavoirs can be observed whatever if the mapkey was registered
- In Creo Parametric 8.0 or earlier, leading in following syntax in config.pro:
mapkey $F2 ~ Activate `main_dlg_cur` `NavigatorOpenCloseChkBtn` 0;
- Or in Creo Parametric 9.0, leading in following syntax in config.pro:
mapkey $F2 ~ Command `ProCmdNavigatorBtn`;
This is a printer-friendly version of Article 401612 and may be out of date. For the latest version click CS401612