Article - CS386073
When defining rotational constraints in Creo Parametric, it prompts: "You constrained a rotational degree of freedom for an entity that does not have rotational degrees of freedom. The rotational constraint will be ignored on those entities"
Modified: 08-May-2025
Applies To
- Creo Parametric 7.0 to 9.0
- Creo+
- Creo Parametric 9.0 to 11.0
Description
- When defining rotational constraints, it prompts warning message: You constrained a rotational degree of freedom for an entity that does not have rotational degrees of freedom. The rotational constraint will be ignored on those entities. Consider applying a rigid or a weighted link in this situation.
- In Creo Simulate, adding a rotational degree of freedom constraint to a solid surface, running an analysis gives an error "The model is not constrained enough in this analysis"
This is a printer-friendly version of Article 386073 and may be out of date. For the latest version click CS386073