Article - CS369555
How to produce multiple references when using Project or Offset features in Sketcher environment since Creo Parametric 9.0
Modified: 01-Jul-2025
Applies To
- Creo Parametric 9.0 to 12.4
- Creo+
- Not applicable to Creo Parametric 8.0 and earlier versions
Description
- When creating a Projection (or an Offset) of a partial chain or a complete loop in Sketcher environment in Creo Parametric 9.0, outcome is a Composite Curve considered as a unique projection (or offset) geometry
- This did not happen in pre-Creo Parametric 9.0 versions, where the same features were used to produce multiple references; is this method change intended?
- How to generate multiple references when using Project or Offset features in Sketcher environment since Creo 9.0?
This is a printer-friendly version of Article 369555 and may be out of date. For the latest version click CS369555