Article - CS347680
What characters and symbols are allowed after tolerance value of Geometric Tolerance in Creo Parametric
Modified: 24-May-2023
Applies To
- Creo Parametric 4.0 to 9.0
- Creo+
Description
- There is the case that a warning like There are invalid characters following the tolerance size value. is shown when entering a character after tolerance value
- What characters and symbols are allowed after the tolerance value
- Warning Concentricity is not supported in the selected tolerancing standard if the tolerance standard is set to ANSI/ASME
This is a printer-friendly version of Article 347680 and may be out of date. For the latest version click CS347680