Article - CS335286
Premature exit when defining a new stack up in Creo EZ Tolerance Analysis and leaving mouse pointer hovering over geometry to select start feature in Creo Parametric
Modified: 01-Jun-2022
Applies To
- Creo Parametric 7.0.2.0 to 7.0.3.0
- Creo Parametric 6.0.5.1
- Creo Parametric 4.0 M140
Description
- Premature exit when defining a new stack up in Creo EZ Tolerance Analysis and leaving mouse pointer hovering over geometry to select start feature
- Does not occur if config.pro option prehighlight is set to no to disable pre-selection highlighting
- Creo Parametric freezes when clicking New Stackup then crashes
- Sometimes dialog appears indicating fatal error with traceback.log, sometimes not
- Seems to happen mostly with large assemblies
- In small assemblies or simplified reps, a stackup can be defined within the extension, however crashes do happen as well, though less frequently
This is a printer-friendly version of Article 335286 and may be out of date. For the latest version click CS335286