Article - CS316923
Thin and long components are not meshing completely in Creo Simulation Live in Creo Parametric
Modified: 09-Jan-2026
Applies To
- Creo Parametric 4.0 to 12.4
- Creo+
Description
- Thin and long components are not meshing completely in Creo Simulation Live in Creo Parametric
- Upon access to Creo Simulation Live environment, thin geometries compared to overall Model Size are unexpectedly not shaded
- Thin walls are not meshing completely
- Failure to capture thin pieces of models
- Results are not shown for flow analysis in Creo Simulation Live.
- They appear instead in a state close to wireframe, for instance as follows:
- Above behavior:
- Can be observed in part and assembly mode
- Often affect Sheetmetal parts (because usually long and thin)
- Persists after having increased sim_live_result_quality config.pro entry to his maximum allowed value 1
This is a printer-friendly version of Article 316923 and may be out of date. For the latest version click CS316923