1. Home
  2. Support
Article - CS283074

Unexpected error message "Standard layers couldn't be reapplied" is given in Creo Parametric 4.0 message area after multiple usage of "Reapply Standard" in TEMPLATE_LAYER check in ModelCHECK report

Modified: 06-Apr-2018   


Applies To

  • Creo Parametric 4.0

Description

  • Unexpected error message is given in Creo Parametric 4.0 message area after multiple usage of Reapply Standard in TEMPLATE_LAYER check in ModelCHECK report
Standard layers couldn't be reapplied
  • Consider a system configured to run ModelCHECK is Save mode and using:
  1. template_solidpart pointing to <part_name_template>.prt (full or absolute path in the system)
  2. E (Error) as setting in Save mode of TEMPLATE_LAYERS check in *.mch file
  3. PRT_TEMPLATE pointing to <part_name_template>.prt (full or absolute same path in the system as the one configured in template_solidpart config.pro option)
  • When creating a new part, all layers are applied as expected
  • Saving it does not give therefore any error related to TEMPLATE_LAYERS check as expected
  • After that, if one or more layers are deleted, and part is saved again, ModelCHECK Report:
    1. Identifies the missing layers as expected
    2. Reports an Error on Standard Layers
    3. Gives access to Reapply Standard functionality
  • When clicking on Reapply Standard the first time:
    1. Standard layers are reapplied from template solid part model as expected
    2. Message area gives the expected message:
Standard layers reapplied
  • ​If Reapply Standard is clicked again (once, or even multiple times)
  1. No change occurs in Layers as expected (because Standard Layers had been already reapplied)
  2. However, Message area gives an unexpected confusing message saying:
'<part_name_template>.prt ' cannot be retrieved.
Standard layers couldn't be reapplied

 
This is a printer-friendly version of Article 283074 and may be out of date. For the latest version click CS283074