Article - CS263089
When working with the 11.0 F000 Windchill Workgroup Manager and CATIA, CATAnalysis from CATPart without material is modified in session after check state in Save Management
Modified: 19-May-2017
Applies To
- Windchill PDMLink 11.0 F000
- Windchill ProjectLink 11.0 F000
- Windchill Workgroup Manager
- CATIA V5R24 SP5
Description
- A CATAnalysis from CATPart without material is intermittently modified in session after check state in Save Management performing the following actions:
- CATAnalysis from CATPart without material is Checked In and present in the Workspace
- Run Catia V5 registered with the Windchill Workgroup Manager
- Open CATAnalysis from the Workspace and go to Save management
- Note that the CATAnalysis is modified in session. If one selects to Close the CATAnalysis from Catia session, there is not a ‘Close’ dialog with Save Yes, No and Cancel. It is also expected that the CATAnalysis should be in an Open state and there should no need to save in after close from session.
- Open CATAnalysis from the Workspace again and go to Save management
- Note that the CATAnalysis is Open in session but ‘Close’ dialog with Save Yes, No and Cancel is appearing after close CATAnalysis from Catia. It is expected that the CATAnalysis should be in an Open state and there should be no need to save in after close from session.
This is a printer-friendly version of Article 263089 and may be out of date. For the latest version click CS263089