Article - CS232912
"Hole" and "Shaft" are not visible in the Tolerance table for Dimension Properties in Creo Parametric
Modified: 05-Nov-2024
Applies To
- Pro/ENGINEER and Creo Elements/Pro Wildfire 3.0 to Wildfire 5.0
- Creo Parametric 1.0 to 9.0
- Creo+
Description
- Tolerance table cannot be set for dimensions properties fro created dimension in drawing
- "Hole" and "Shaft" are not visible in the Tolerance table for Dimension Properties
- With some drawings/dimensions we can not select Hole or Shaft tolerance dimension
| Observed: |  |
| Expectation |  |
This is a printer-friendly version of Article 232912 and may be out of date. For the latest version click CS232912