Article - CS22767
How to create angle dimensions smaller than 1 degree in Creo Parametric
Modified: 24-Jun-2025
Applies To
- Pro/ENGINEER and Creo Elements/Pro Wildfire to Wildfire 5.0
- Creo Parametric 1.0 to 12.4
Description
- Inability to create an angular dimension through Insert > Dimension > New References command when the angle is less than 1º
- How to create angle dimensions smaller than 1 degree
- How to show a small angular dimension on a drawing
- Unable to create a small angle dim in a drawing with a cross section drawing view
- Unable to create a angular dimension less than 0.5°
- How to create small angle dimension in the drawing
- Cannot create 3D angular annotation in an area, where Sketcher angular dimension succeeds
This is a printer-friendly version of Article 22767 and may be out of date. For the latest version click CS22767