Article - CS182581
Information about sketcher diagnostic tools in Creo Parametric
Modified: 23-Jan-2025
Applies To
- Creo Parametric 1.0 to 8.0
Description
- How to diagnose a sketch that cannot be completed with warnings
- Sketcher fails to complete
- How to use Shade Close Loops, Highlight Open Ends, and Overlapping Geometry
- Is it possible to disable open and closed sections check in sketch?
- WARNING: Not all open ends have been explicitly aligned.
- Cannot have mixture of open and closed sections.
- Multiple loops must all be closed in this section.
- Section is incomplete for reasons listed in the message area. Exit sketcher?
This is a printer-friendly version of Article 182581 and may be out of date. For the latest version click CS182581