Article - CS17031
Unable to place or move geometric tolerance or set datum feature symbol (DFS) with dimension on drawing in Creo Parametric
Modified: 23-Jul-2025
Applies To
- Creo Parametric 1.0 to 12.4
- Pro/ENGINEER and Creo Elements/Pro Wildfire 5.0
- Creo+
Description
- Unable to move geometric tolerance or set Datum Feature Symbol (DFS) with dimension on drawing
- Unable to place geometric tolerance or set datum on dimension with following error message
- You cannot link a Pro/DETAIL gtol to a draft dimension
- Selected part is not active. Select again
- Gtol cannot be placed on the dimension in a different part/assembly
- You cannot link a part/assembly gtol to a drawing dimension
- Selected part is not active. Select again. error reported when attempting to place datum In Dim in drawing
- Unable to set a set datum on a defined dimension in drawing
- DFS in specific drawing moves to the opposite direction than intended in 3D
This is a printer-friendly version of Article 17031 and may be out of date. For the latest version click CS17031