Article - CS115533
Mesh creation in Creo Simulate fails with message: "AutoGEM may not be able to complete because the volume boundaries either intersect or overlap near the highlighted surfaces"
Modified: 03-Aug-2017
Applies To
- Creo Parametric 1.0 to 2.0
Description
- Mesh creation fails with the diagnostic message:
- Could not complete creating elements on all of the selected entities.
- Only a partial set of elements was created and AutoGEM restarted automatically
- When it fails again, the only additional info is:
- AutoGEM may not be able to complete because the volume boundaries either intersect or overlap near the highlighted surfaces.
- The surfaces seem to relate to some shell pairs, but there is no way of figuring out what is overlapping
- Need better diagnostics
This is a printer-friendly version of Article 115533 and may be out of date. For the latest version click CS115533