Article - CS41916
Difference between dimension types "d", "ad", "add" and "dd" in Creo Parametric
Modified: 11-May-2025
Applies To
- Pro/ENGINEER and Creo Elements/Pro Wildfire 2.0 to Wildfire 5.0
- Creo Parametric 1.0 to 11.0
- Windchill PDMLink 9.1 to 11.0
Description
- Difference between dimension types d, ad, add and dd
- Difference between dimension types dxx, adxx, addxx and ddxx, where xx is the dimension ID
- If a particular drawing is saved using "save as" and some dimensions are erased in the file thus saved, changes are applied to the original file.
- Creo 7.0 If the dimension is manually marked, the geometric tolerance cannot be placed on the dimension line like the displayed dimension. Is there a good solution?
- Geometric tolerances and datum annotations in two-dimensional drawings cannot be attached to dimension annotations.
- After modifying the 3D model file, the location of dimensions are changed in 2D drawing.
This is a printer-friendly version of Article 41916 and may be out of date. For the latest version click CS41916