This is a PDF version of Article CS297446 and may be out of date. For the latest version click here
Article - CS297446

Behavior to access "Repeat" and "Pattern" functionalities after graphical selection of a component's entity (surface or edge) is not consistent in Creo Parametric assemblies

Created: 04-Dec-2018   |   Modified: 04-Dec-2018   

Applies To

  • Creo Parametric 1.0 to 5.0

Description

  • Behavior to access Repeat and Pattern functionalities after graphical selection of a component's entity (Surface or Edge) is not consistent in Creo Parametric assemblies
  • After selection of a surface or an edge of a given component in the context of a top assembly, system:
    • allows access to assembly Pattern feature, with consequence to propose a pattern of the component owning the entity previously selected
    • let however unexpectedly grayed out the access to assembly Repeat feature