Article - CS284792
Unable to place a GTOL under a tapped hole note dimension in Creo Parametric
Modified: 10-Aug-2023
Applies To
- Creo Parametric 4.0 to 11.0
- Creo+
Description
- Unable to place a GTOL under a tapped hole note dimension
- The GTOL is directly placed in the elbow of the tapped hole note dimension
- GTOL added to Hole feature annotation does not display as expected
- Unable to attach a GTOL below a note
- GTOL gets attached at the end of the leader
- Note will be placed above the leader
- The leader will not be at the center of the note
- When attaching a feature control frame to a note (such as a thread note) it does not follow any standards
- The note is moved on top of a line which then attaches to the feature control frame. The leader line should go to the note, with the FCF placed below
- Unable to select threaded holes note to place GD&T advisor
This is a printer-friendly version of Article 284792 and may be out of date. For the latest version click CS284792