Article - CS99692
How to show the DRILL_DIAMETER and DRILL_DEPTH values for simple holes in the hole table in Creo Parametric??
Modified: 08-Jul-2024
Applies To
- Pro/ENGINEER and Creo Elements/Pro Wildfire 2.0 to Wildfire 5.0
- Creo Parametric 1.0 to 11.0
Description
How to show in the Hole Table, DRILL_DIAMETER and DRILL_DEPTH values for simple holes?
- Create a simple hole on a part
- Create a drawing and setup the Hole Table by adding parameters such DRILL_DIAMETER and DRILL_DEPTH
- Show the Hole Tbale and note that DRILL_DIAMETER and DRILL_DEPTH cels are empty
- Note that for Standard Holes, such parameters can be shown.
This is a printer-friendly version of Article 99692 and may be out of date. For the latest version click CS99692