Article - CS62138
Interface required for Flexible Modeling and steps to configure for Creo Parametric
Modified: 15-Sep-2026
Applies To
- Creo Parametric 1.0 to 13.4
Description
- Which license is required to enable Flexible Modeling
- "Flexible Modeling” tab is not available/showing in interface
- Ribbon tab for Flexible Modeling is not switched on
- Unable to use flexible modeling operations
- Flexible Modeling tab missing from ribbon
- Unable to access flexible modeling commands under Flexible modeling tab
- Flexible Modeling command are grayed out though the license is configured
- Is Flexible Modeling tab available in assembly mode?
This is a printer-friendly version of Article 62138 and may be out of date. For the latest version click CS62138