技術文章 - CS50244

How to drive the value of an Optimization design constraint through a parameter in Creo Parametric

修改時間: 03-May-2017   


套用到

  • Creo Parametric 1.0 to 4.0

描述

How to drive the value of an Optimization design constraint through a parameter
 
Is it possible to use a parameter type: Real Number instead of a value in an 'Optimization' analysis under 'Design Constraints' a target value is set in Creo Parametric?
This is a PDF version of Article CS50244 and may be out of date. For the latest version https://www.ptc.com/tw/support/article/cs50244