Artigo - CS20578
Is it possible to split a single solid surface into multiple patches in Creo Parametric
Modificado: 03-Nov-2022
Aplica-se a
- Pro/ENGINEER and Creo Elements/Pro Wildfire to Wildfire 5.0
- Creo Parametric 1.0 to 9.0
Descrição
- How to split a single solid surface into multiple patches at one go in Part/Assembly mode
- How to divide a surface to make two patches in order to use them in Ansys or Simulate
- How to split a surface based on the contour of another line, another surface or datum plane
Esta é uma versão em PDF do artigo 20578 e pode estar desatualizada. Para a versão mais recente, clique CS20578