기술 문서 - CS277017

About Creo Augmented Reality (AR) Design Share and Spatial Target publishing capabilities in Creo Parametric 4.0 M040 and later

수정한 날짜: 15-Jun-2020   

적용 대상

  • Creo Parametric 4.0 M040 to 7.0

설명

  • About Creo Augmented Reality (AR) Design Share and Spatial Target publishing capabilities
  • How to quickly publish augmented reality experiences from Creo for use with the Vuforia View app
  • Non-supported devices report the following error in Vuforia View app:
    • Sorry! 3D elements can't be displayed because either spacial tracking isn't supported on this device, or ThingView renderer has not been enabled in Settings. 
  • New Premium offering available in M040 in addition to the previous Free AR functionality
  • ThingMarks will no longer be used starting in Creo Parametric 4.0 M040
    • Spatial Target tracking will be used instead
      • Spatial Tracking does not require a printed ThingMark; instead a hyperlink can be used to start the experience in the View app and the user just needs to point the camera at a horizontal surface then tap to place the experience
      • ThingMarks published from Creo 4.0 M010-M030 will still function as will publishing new ThingMarks from M010-M030
        • ThingMarks from M010-M030 will be automatically updated to Spatial Targets (without rev-bumping the model) when opened in M040
        • Users will need to republish from M040 to use the new Spatial Tracking
  • ThingMarks have been reintroduced alongside Spatial Targets in Creo 4.0 M070
이는 기술 문서 CS277017의 PDF 버전이며, 구 버전일 수 있습니다. 최신 버전 https://www.ptc.com/ko/support/article/cs277017