기술 문서 - CS187463

How to open a model in a specific Combined State in Creo Parametric

수정한 날짜: 06-Aug-2021   


적용 대상

  • Creo Parametric 1.0 to 7.0

설명

  • Cannot save the Model so that it opens with a specific combined state other than the default state
  • How to open a model in a specific Combined State
  • How to open an assembly by default in a Combined State
  • Is it possible to set the display to a specific Combined State when the Annotations tab is opened?
이는 기술 문서 CS187463의 PDF 버전이며, 구 버전일 수 있습니다. 최신 버전 https://www.ptc.com/ko/support/article/cs187463